on 02-14-2006 4:56 PM
Hi,
I have defined some start conditions via txn 'swb_cond' and they doesn't seem to work? Is it possible to debug the start conditions? Is it dependent on workflow customizing by any means i.e. event queue based workflows.
I am not sure if this question has already been answered in this forum but I was unable to find any posts with relevant input I am after.
Thanks,
Surendar
Hi Surendar,
Just to ask the obvious: are they active? (green light in SWB_COND). Remember activation is also client-dependent, so you need to switch them on again if your'e testing in a different client.
Failing that, there's a test button in the condition editor where you can verify your logic.
Or you can trigger/test your event using SWUE.
Hope that helps,
Mike
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Mike,
Thanks for your reply.
The start conditions were active and the testing those conditions give me correct results but when I try to raise a event via SWUE the start conditions does not seem to work.
Is there any way by which I can debug the conditions? Or I should go with check function?
Thanks,
Surendar
Got it!!!
Put a breakpoint in function module 'SWB_CHECK_FB_START_COND_EVAL'. But make sure the check function in txn SWE2 has got value 'SWB_CHECK_FB_START_COND_EVAL'. All start conditions are maintained in table 'SWBRULECOM' and you can put a breakpoint at the select statement.
SWB_COND_EVAL is then used to determine the logic stored in start conditions.
Cheers,
Surendar
User | Count |
---|---|
61 | |
9 | |
7 | |
6 | |
6 | |
6 | |
5 | |
5 | |
5 | |
5 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.