cancel
Showing results for 
Search instead for 
Did you mean: 

What is the cause of BI 7.0 Process chain encountered sudden stop on the next metachain?

Former Member
0 Kudos
76

Hi everyone.

      I would like to get your opinion on this issue. I have 10 metachains which loads master data to an openhub. But last week we encountered an issue on one of the metchain. The metachain 0mat_unit did not run but the preceeding metachain 0mat_sales run successfully and did not prompt any error message or any short dump message and its status is green but the next chain the 0mat_unit did not run. I just did manual loading and everythings goes fine. I just want to know what might be the cause of it. We did not do any changes in the metachain so its not possible that the metachain is deactivated. the start variant of 0mat_unit is metachain API so it should run after the 0mat_sales was finished on its job. Any idea on this? thank you very much

View Entire Topic
Former Member
0 Kudos

Hi Cris,

Pls go through

http://scn.sap.com/message/8393439

This many help u

Thanks

Aakash

Former Member
0 Kudos

Hi Aakash,

     This one is helpful but it did not state on how to check if there was a bounce of abap stack in BW before this issue happened.

Former Member
0 Kudos

Hi Cris,

Even I'm not aware of ABAP Stack .

Have you done any changes in the current process chain flow.

You can try this De schedule the chain.....then again Schedule it back

Thanks

Aakash