cancel
Showing results for 
Search instead for 
Did you mean: 

Value of expression '0' cannot be used as the target of an assignment

Former Member
0 Kudos

In one of my custom workflow steps, there is an error "Value of expression '0' cannot be used as the target of an assignment". It implies that a binding error occurred in runtime the value couldn't be assigned to the target.

However, I removed all bindings from the binding editor and still the same error. What could cause this?

I am in ECC 6.0.

Appreciate it...

Accepted Solutions (0)

Answers (5)

Answers (5)

Former Member
0 Kudos

I think you need to figure out which step is still having this error and act accordingly. Sometimes deleting and adding the same step solves the problem:))).

Thanks

Arghadip

Former Member
0 Kudos

you can click on the error and it will take you to the exact location where the error occured. then you can analyse the exact problem.

Former Member
0 Kudos

Thanks Sudhir.

I ran it, but didn't fix the problem.

I'll give you credit for responding so quickly

Regards,

Steve

Former Member
0 Kudos

I was building a custom workflow using BUS2081 modified.

Former Member
0 Kudos

Try using SWU_OBUF, some times the changes will not be effected immediately.