on 2009 Mar 09 5:05 PM
Hello,
I have a series of WAD templates that have 4 tabs in each, always identical. Users navigate between templates through buttons (SET_TEMPLATE or RRI).
Requirement is if user starts from tab 1, he goes to tab 1 in the next template. Same for tab2, tab3 and tab4.
I tried adding the TRANSFER_STATE command to the SET_TEMPLATE command in the button, but it has no effect. Templates always open with default value, ie tab1.
Any advice?
Thanks,
JLT
Hi Jean-Luc
did you try with another parameter ? Sometimes the parameters are not well interpreted. I had the issue with some webservices
So I would advise to try with another parameter in the same tab, to be sure that it is correctly interpreted.
PY
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Thanks for the tip Pierre-Yves,
I could make it work by removing the SET_TEMPLATE command, ie using TRANSFER_STATE alone. It's like SET_TEMPLATE and TRANSFER_STATE could not be used together in that specific case.
JLT
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
66 | |
10 | |
10 | |
10 | |
10 | |
8 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.