cancel
Showing results for 
Search instead for 
Did you mean: 

Sysfail status in SMQ1

former_member335553
Active Contributor
0 Kudos
275

Hi

I have sysfail error in tRFC and qRFC (SM58 and SMQ1) Error message with function module not found and exception raised .Scenario is from ECC-XI-Third party system.

Checked for dumps in SAP XI where in I could get the following message " Error in ABAP Program "SAPMSSY1"and the program is terminated Probably due to an error in program .this is a standard Program and moreover this interface has run successful till april end

Please let me know your suggestions to clear off the sysfail status

Accepted Solutions (0)

Answers (4)

Answers (4)

Former Member
0 Kudos

Hi

check the reply of Rob at this thread regarding error with SAPMSSY1 program

Regards

Abhishek

former_member335553
Active Contributor
0 Kudos

Hi

Bringing it to the top .Still unresolved

The error popped up after support pack installation .What all entries I need to check over for this RFC scenario to presume .

SM59 working fine

Please post your views

former_member335553
Active Contributor
0 Kudos

Hi

Bringing it to the top .Still unresolved

The error popped up after support pack installation .What all entries I need to check over for this RFC scenario to presume .

SM59 working fine

Please post your views

former_member335553
Active Contributor
0 Kudos

Any ideas on this ?

Former Member
0 Kudos

Anusha

Can you provide more log detail?

Please check the qRFC log from SMQ1?

PJ

former_member183908
Active Contributor
0 Kudos

Hi

-->Refer this it explains how to resolve the SYSFAIL issue.

/people/sap.user72/blog/2005/11/29/xi-how-to-re-process-failed-xi-messages-automatically

Thanks

Former Member
0 Kudos

Anusha

Can you provide more log detail?

Have you also check the qRFC log from SMQ1?

Hope this help.

PJ

Former Member
0 Kudos

Can you write the text message of the dump?