Showing results for 
Search instead for 
Did you mean: 


Former Member
0 Kudos

Hi Every one, I have completed installation of SolMan 7.1 SPS04 patch 9. I am having many dumps which is related to BI and BW activation. I have gone trough many blogs here in SDN but none of them indicates what to do if you have no BW or BI in sap landscape.

Our landscape dose not have BI or BW and I am unable to prevent these dumps from generating. I have also implemented all the Snote.

I appreciate if some one can help me in stopping these dumps.

In another note, since we do not have BI or BW in our sap landscape, status of Basic configuration is yellow. Would this cause issues when configuring E2E solutions?

Your reply is appreciated.

Category               ABAP Programming Error
Runtime Errors         CREATE_DATA_UNKNOWN_TYPE
Except.                CX_SY_CREATE_DATA_ERROR
ABAP Program           SAPLSMD_FUNC
Application Component  SV-SMG-DIA
Date and Time          15.06.2012 09:06:21

Short text
     CREATE DATA: The specified type "/BI0/V0DBH_C01H2" is no valid data type.

What happened?
     Error in the ABAP Application Program

     The current ABAP program "SAPLSMD_FUNC" had to be terminated because it has
     come across a statement that unfortunately cannot be executed.

What can you do?
     Note down which actions and inputs caused the error.

     To process the problem further, contact you SAP system

     Using Transaction ST22 for ABAP Dump Analysis, you can look
     at and manage termination messages, and you can also
     keep them for a long time.

Accepted Solutions (0)

Answers (2)

Answers (2)

Former Member
0 Kudos


Adding to Roland''s reply above - the SolMan itself has BI Content which allows activation of BI on a client within the SolMan itself. You would not need a separate BW system in the landscape.

Activating BI content on a client within the SolMan can be done via the SOLMAN_SETUP wizard itself.

Please check setup guides from below link:



0 Kudos

Hi Kourosh,

The issue you are facing is because the BI content is not fully active

in your SolMan system.

After the installation, SOLMAN_SETUP should be run. During setup
report CCMSBI_SETUP_E2E should be scheduled as it is supposed to install
missing InfoProviders.

Please make sure that the setup was run successfully if this is not the
case please run the report CCMSBI_SETUP_E2E in SE38 in the BI client.

Please review KBA note for more inforamtion :1680556 : CREATE_DATA_UNKNOWN_TYPE    CX_SY_CREATE_DATA_ERROR    /BI0/ 

Kind regards,