smart forms and migo transaction

[Former Member]

Hi,

I am new with SAP. I am confused by this and I need help.

I have to create a SmartForms based on a Migo transaction. I know in other transactions (vf03, etc) I can connect my smartform to print program and than I will get input parameters and output view of my Smartform. I have been found this by spro transaction.

Does it works in that same way in a migo transaction?

If once someone has created a print programm suitable to my SmartForm, how can I get a name of it?

I will appreciate any feedback.

W.P.

[Former Member]

Hi,

If you want to know the driver program of your smartform, follow the below steps:

1. go to SMARTFORMS transaction.

2. Give the smartform name and press display

3. then ENVIRONMENT-> Function module name and then copy the function module name

4. goto se37 and paste the function module name and prees display

5. Now double click on the Function module name you will get the pop up of where-used list

6. select the programs and execute

7. you will get the Driver program

Regards,

Azaz Ali.

[Former Member]

hi

check out tcode NACE or the table TNAPR.

regards,

sham

[Former Member]

Hi!

Welcome in the forums.

Check it out in transaction OMBU. In this you can't use Smartforms.

There is another transaction, which might be much more useful: M706. In this you can use Smartforms.

The full customizing can be located it SPRO - Material management - Inventory management and physical inventory - Print control/Output determination

Regards

Tamás

Message was edited by:

Tamás Nyisztor

Message was edited by:

Tamás Nyisztor