SM50 Trace and Active Components defaults

[Former Member]

I am looking for some advice on why certain users' active components have defaulted to trace level 2 and all components are selected. My SM50 will have yellow lines all over the place.

It's probably something simple but how do I verify the defaults for users and make the necessary changes so the log directory stops exploding?

Thanks,

Ryan

[Former Member · Accepted solution]

Hi,

You can change the trace level back to what you require. Please following following route.

SM50->Process->Trace->Active components. This gives you another screen where you can change the settings.

Hope this helps.

Manoj Chintawar

[Former Member]

Looks like Note 357683 cleared up the yellow lines but it is still creating trace files for every EDI document we send through. Not sure on where to go from here but just sending another update.

[Former Member]

A couple of things could be going on. After looking through the logs and seeing a new error we are looking into Note 357683 - Trace adopted by remote client and Note 987134 - Trace level spontaneously increases in kernel release 46D.

Just an update.