on 2005 Jun 03 1:45 AM
HI
Is it possible to check set up tables after set up process.My=20
requirement is allready set up process has done for Diffrent
selection=20
documents on SD.
Now i want to fill set up tables so first i need to check, it is=20
available in cluster tables or not.Plz clarify my doubt if possible plz = replay=20 me. =20
davichu
Davichu,
Pls follow this,
To see Your Data run transaction 'RSA3' ...If setup procedure propely done... Other wise no data list available.
Using the transaction NPRT(Log for setup of statistical data)in R/3 side, you can find all the log infomation regarding setup tables and their selections.
TQ
Kumar
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Kumar,
I got it .. works
Davichu
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Even though you have the table name "Extract structure"SETUP but it is a cluster table & you will not be able to see / make any sense of data.
Its better not to use it this way, you can run Simulation or use extractor checker for testing purposes.
regards
Vikash
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Davichu,
It is possible to check setup tables when u do the statictical setup of an Application Component.Once u do that then you can check the setup table(Extract_structurefollowed by SETUP is the table name).
But before u go for setup atleast one of the datasource in that particular Application component Say SD. should be active.
Assign points if it helps you..
Cheers
Lisa
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
66 | |
10 | |
10 | |
10 | |
10 | |
8 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.