cancel
Showing results for 
Search instead for 
Did you mean: 

RSAP0001 Exit not called during extraction

Former Member
0 Kudos

Hi Everyone,

I have a problem while using RSAP0001 in R/3 for the extractors. In Development System its fine but not during my QA testing in the QA System.

The Project and the Program and the Include is all activated and active.

But when I do an execution of the datasource 2LIS_02_ITM (which I have added in a code in the customer exit to populate some of the fields) in RSA3 using debug mode, I notice that it skips the customer.

I placed a breakpoint at the case statement for the datasource in the customer exit and notice it does not go in at all.

Is there anything that could cause the problem?

Everything is active but its still not working.

Please help.

Thanks.

Regards,

Shunhui.

Accepted Solutions (0)

Answers (1)

Answers (1)

edwin_harpino
Active Contributor
0 Kudos

hi Shunhui,

assume all objects have been successfully transported.

try if helps deactivated and activate again the project in dev and transport.

Former Member
0 Kudos

Hi AHP,

Yes, all the objects are active and susscessfully transported previously.

You mean I have to activate it again?

Just to check, if i were to make changes in the customer exit for transactional datasources EXIT_SAPLRSAP_001 and added in codes to the include ZXRSAU01 within the exit and activated the changes for the customer exit from SMOD, do I need to activate the Project again from CMOD?

Thanks.

Regards,

Shunhui.

edwin_harpino
Active Contributor
0 Kudos

hi Shunhui,

yes, try to de-activate and activate again with CMOD.

your enhancements will not work until you activate the project.

check threads for smod and cmod

hope this helps.

Former Member
0 Kudos

Hi AHP,

Would you happend to know if there are any documents that states the procedure or necessary steps to be carried out when making changes to the customer exits?

Thanks.

Regards,

Shunhui.

Former Member
0 Kudos

thanks, it's just what i want.