results row shown only at the bottom and not at each value level

[Former Member]

Dear Experts

I have a report based on a multiprovider consisting infosets and a cube.

There are several row characteristics shown. 1 of these were set to show results row. But the results row is not shown at each value level but at across all its characteristics level, ie. at the bottom of this characteristic. So, only 1 results row shown and not 1 results row per each value of this characteristic.

Some other characteristics are showing multiple rows of results rows but at a certain grouping level and also not at per value level.

Please advise what could be the cause.

regards

Pascal

[former_member182343 · Accepted solution]

Go to Charecterstic properties and choose Result row as Display always for row.

Report become more granular, by this.

Regards,

rvc

[Former Member · Accepted solution]

Dear Experts

Solved.

Due to the concept works like this:

To see results row for a characteristic, must set it to the char infront, not to the char itself.

But then when user re-arranges the position of the row chars, there could be an issue.

Is this a constraint of BEx?

regards

Pascal

[anshu_lilhori]

Hi,

Enable Result Row for all the characerstic and see if it gives you desired output or not.Then based on the output you can decide for which characterstic level you need to keep the reult Row and for which you need to supress.

Hope it helps.

Regards,

AL