report not opening in internet explorer when i click execue !

[Former Member]

Hi All,

I have a report built .... in the query designer when i am clicking the execute button to open that report in internet explorer ...it says that : 'the address is not valid' .... is there any configuration problem ....if it is....then what are the exact steps to resolve this issue .... ?

Regards,

Ashutosh Singh

[brian_keenan · Accepted solution]

Is the address valid? if the ICM has not been configured then it cannot run, is the call going through the portal? then look at the messages from the support desk tool which will guide u though the setup.

Please run SAP NetWeaver BI Diagnostics & Support Desk Tool as described in note 937697 to verify your installation.