cancel
Showing results for 
Search instead for 
Did you mean: 

Replace standard pop up

Former Member
0 Kudos

Hey,

Currently I'm using a standard function for an address search

in my BSP. I have problems with addresses that contain a great

amount of premises, the function cuts down the number of

records over 100, when I set a flag on calling the function.

If I don't set that same flag, in SE37 a pop up is shown,

'do you want to continue with more than x records?'.

Is there a way (other than rewriting the entire function)

to eventually catch that popup and answer with 'continue'?

if i don't dump on that function call would be nice.

Any ideas are welcome

grtz

Koen

Accepted Solutions (0)

Answers (1)

Answers (1)

Former Member
0 Kudos

Hi,

it would help more if you tell us the name of your function. I don´t think it is possible to answer a pop-up question, which is part of the SAP GUI, from within the SAP WebGUI. You must consider that not all your end users will have access to the SAP R/3 system, therefore you must either rewrite the function or search for another one that does not display that message.

Uhmmm, perhaps it could help if you let the function run with 'IN BACKGROUND TASK' (read parameters for CALL).

Former Member
0 Kudos

the used function is:

ECRM_ISU_COMP_ADDRESS_SEARCH

there is an OSS note which allows me to go up to 200 results

but even then it can happen that not all matching records

are shown, i've created a message to make a bigger scope

on the search results

grtz

Koen