cancel
Showing results for 
Search instead for 
Did you mean: 

Reg: Custom UME attributes

Former Member
0 Kudos
60

How to add custom UME attributes

Accepted Solutions (0)

Answers (4)

Answers (4)

Former Member
0 Kudos

I have set the attributes in UME configuration. But how to retrieve these values in webdynpro. Where can i get the namespace details of these attributes

Former Member
0 Kudos

where can i give the default values to this custom attributes

rudradev_devulapalli3
Active Participant
0 Kudos

Hi Prashanthi,

The User Management Engine (UME) provides data source configuration files that define a configuration for standard scenarios. If none of these files cover the scenario that you require, you can modify the existing configuration files according to your requirements.

1.Download the data source configuration file that most closely meets your requirements.

For more information about accessing the file when the AS Java is running, see [Accessing Data Source Configuration|http://help.sap.com/saphelp_nw04s/helpdata/en/f3/84fc50c515d44aa008badfbedca14d/content.htm] Files Online.

For more information about accessing the file when the AS Java is not running, see .[Accessing Data Source Configuration Files Offline|http://help.sap.com/saphelp_nw04s/helpdata/en/0f/bdd93f130f9115e10000000a155106/content.htm]

2.Adapt the file as required.

3.Verify the correctness of your data source configuration file using the document type definition (DTD) file, which you can find at the same location as the data source configuration files.

4. Upload the data source configuration xml file under a different name..

To configure UME to use it, set the UME property ume.persistence.data_source_configuration to the name of the new configuration file.

So that it will take the newly created ume config xml file which will have newly added attributes.

Go thorugh the following links which will give an idea on custom attributes

http://help.sap.com/saphelp_nw04s/helpdata/en/b7/14d43f2dd44821e10000000a1550b0/content.htm

http://help.sap.com/saphelp_nw04s/helpdata/en/f3/84fc50c515d44aa008badfbedca14d/content.htm

Hope this helps you...

Regards,

Rudradev Devulapalli

Reward the points if helpful

Former Member
0 Kudos

check the below thread

Points are welcome if it helpful

Koti Reddy

Former Member
0 Kudos

But in the portal i am not getting modify configuration under user admin

Former Member
0 Kudos

Hi Prasanthi,

For adding UME attributes, Go to Sys Admin -> Sys Confg -> UME Confg -> Modify Confg -> User Admin UI Tab -> Give the custom attribute name in Administrator-Managed Custom Attributes. After adding the custom attribute, do a restart of the portal. Then this custom attribute, comes under Customized Information tab of the User in User Admin.

Regards,

Venkatesh. K

Former Member
0 Kudos

check whether do you have system admin role or not to perform this?

Koti Reddy