cancel
Showing results for 
Search instead for 
Did you mean: 

Process chain display

former_member698542
Active Contributor
0 Kudos
430

Hi,

I have created new client from development client. The process chains are transported to the new client. When we double click on the process chain, the process chain (network view) is not displayed on the right side of the screen.

Kindly suggest to overcome this issue.

thanks and regards

Murugesan

View Entire Topic
former_member186445
Active Contributor
0 Kudos

i believe you need to go to change mode to see them. and then you can activate them.

M.

former_member698542
Active Contributor
0 Kudos

Hi,

When I click o the change button, message ** Changes to repository or cross-client customizing are not permitted ***.

thanks and regards

Murugesan

Former Member
0 Kudos

Hi ,

This is because , the new system is not open for change.

Earlier, I think the process chain was not transported properly. Did the transport log say something. Just capture the process chain again in a transport request and transport the same.

Make sure all the required objects are migrated.

Cheers

Chanda

Former Member
0 Kudos

Hi Murugeson,

You should go to SCC4 and change the section;

Changes to Respository

former_member186445
Active Contributor
0 Kudos

you should be able to activate the pc in your system...

check this by:

go to transport connection and hit thebutton ' object changeability (it's also the red/yellow truck symbol)

now look for process chain (TYPE = RSPC). it should be set to everything changeable

M.

former_member698542
Active Contributor
0 Kudos

Dear Tibollow,

As per your suggestion, I set the object changeability to changeable. After that also the same issue. The network diagram is not displayed on the right side of the screen. The error message *Changes to Repository or cross-client Customizing are not permitted* displayed.

thanks and regards

Murugesan

former_member186445
Active Contributor
0 Kudos

use SCC4 Double click on client then Click on change button

Select "Changes without automatic Recording" under 'Changes and transports for client-specific objects' tab and

select "changes to repository and cross-client customizing allowed" under 'Cross-client object changes'.

Former Member
0 Kudos

Hi

this is the authorization issue. u can double click on process chain & when u get that error msg open the new session with tcode su53 there u get a screen showing the Auth object. u can ask for the auth of that activity to basis.

thanks

neha