outbound enabler config with 2 relay severs

[ddeconin]

Question :

When setting up an outbound enabler to connect to 2 relay servers, what is/are the correct and/or advised setups?

1. Create 2 outbound enablers, one to each relay server
2. have 1 -cr line with one of the relay servers only
3. have 1 -cr line, with 2 relay server entries ( whats the right syntax then?)
4. have 2 -cr lines , one with each relay server (is that even possible?)
5. point the -cr to a LB that ends up on one of the relay servers

[regdomaratzki · Accepted solution]

#5 is the correct answer, assuming that you have properly setup the Relay Server configuration files on the two Relay Servers in the farm so they are aware of each other.