cancel
Showing results for 
Search instead for 
Did you mean: 

Master data and attributes?

Former Member
0 Kudos
53

Expert's,

Please go through this scenerio and answer the questions?

I have master data ZSTAT for this we have mainitaned the attribute called ZATT.

The data for these is not coming from source.So there is routine in UR which manipulates and updates the ZSTAT as I,N and T based on the conditions given in the UR.But Now If I look at the attribute ZATT I could see only I and N data.How this has maintained.This had done by our onsite folks.My doubt is How did we get only two values for attibute when we are having 3 values for Master data?

Points will be definitely assigned for the right answers?

Thanks in Advance.

Vasu.

View Entire Topic
Former Member
0 Kudos

Hi

Debug the UR ,if you feel everything is ok, then the data uploaded will not be fulfilling the condition you have for T

Regards

N Ganesh

Former Member
0 Kudos

No,

UR is perfectly working.And the myquestion is when ZSTAT is updated with I,N and T How the Attribute ZATT is attribute is updated with only I and N without T.

If I look at the cube for both ZSTAT adn ZATT .

For ZSTAT I could see I,N,and T.But for ZATT I could see only I and N.

Hope I am clear.

Former Member
0 Kudos

Hi

Pls clarify

For the cube, the data for I , N and T are available

For attribute, for T not availabe..is it so?

Have you checked in the master data table ....every master data table have values of attribute stored in the next column

Go to the master data infoobject of the attribute and see whether all I, N and T are there

Regards

N Ganesh

Former Member
0 Kudos

Yes I have checked in the master data table .

It is as shown below.

For I in Mater data I in attribute

N in Master data N in attribute

and T in Master data N attribute.

Hope This is enough to clear my doubt?

Former Member
0 Kudos

can any one look into it?

Former Member
0 Kudos

Please any one can look into it???

Please...

Former Member
0 Kudos

Please any one can look into it?