Load data to flat table

[Former Member]

Hi all,

I'm new in BW. I need to transfer data from file to flat table. On RSA1 I've created all necessary component: data store, info source, transfer structure and then I've created Info Object.

Under tab "External Data" the Preview is ok (I can see data get from file in correct columns).

When I try to Start load immediately I see the message "data was requested" but in corresponding flat table no data are stored. Under tab "Processing" I check "Data target only".

What missing for correct upload?

Thanks in advance

Federica

[former_member666940]

Hi,

Check the transfer rules and update rules are correctly mapped / defined.

If Not, Create update rules.

-SRS

[Former Member]

Hi SRS,

transfer rules are ok, preview work fine also here.

Thanks

Federica

[former_member207028]

Hi,

In processing tab change the processing to PSA and data target and load data again. check data in PSA.

what is data target (infoobject or DSO or Cube)

Regards

Daya Sagar

[former_member205352]

I think you loaded only till PSA.

Run DTP.