cancel
Showing results for 
Search instead for 
Did you mean: 

LO EXTRACTION

Former Member
0 Kudos
42

HAI,

I AM VERY NEW TO THE SUBJECT AND AS WELL AS TO THE FORUM..

CAN ANY ONE EXPLAIN IN DETAIL ABOUT THE REPAIR FULL REQUEST. IT IS AVAILABLE ONLY FOR THE IP CONNECTED TO THE DSO , CAN'T WE DO REPAIR FULL FOR THE INFO CUBE.............

THANK YOU,

SIVA

Accepted Solutions (1)

Accepted Solutions (1)

ravi_chandra3
Active Contributor
0 Kudos

HI

Repair full request is used to extract the missed delta record . Repair full request is used in the DSO only because in ODS for FULL loads activation not possible after delta initialization. So we need to use Repair full option only to load data into ODS after delta for any missing records.

Repair full request will load the data into the ODS in overwrite mode.But if we perform full load in infocube then there is a chance for redundancy of data.

Hope u got it,

Assign points,

Thanx &R egards,

RaviChandra

Edited by: Ravichandra.bi on Dec 23, 2011 8:37 AM

Answers (2)

Answers (2)

Former Member
0 Kudos

Hi Siva,

if the data target already contains data from an initialization run or delta for this DataSource/source system combination, then to request a full load for a selection we need to flag the request as Repair full request from the scheudler menu. this will keep your delta intact.

Keep in mind that it may result in duplicate data in the DSO. so before you do a full repair you must make sure that all data for that particular selection ( for which you run repair full request ) is deleted .

Regards,

Neeraj.

Former Member
0 Kudos

hi Siva.... welcome to this forum.

if you initialized from the source and you may be haing delta loaded or not, but you need to load a full load for specific documents or range of records, you can do full, but when you activat it, it will give you error. Then to over come at technical error, you have the optio to by pass using repair full. Remember this repair full is applicable only BW earlier than 7.0.

Now in 7.0, even after you do initialization it will let you do a full, there is no repair full. Hope that holps.

There is no repair full going to the cube, as you know there is no activation involved in cube data load. Repair full is need only to overcome the activation problem. Again, ODS now DSO has three tables (Active, change log and new table) so activation will transfer the record from new table to change log table and error happen during that time. In cube we have as many has the fact and Dimention table, but there is not transfer or records.

thanks.

Wond