issues after deleting a navigational attribute

[former_member730190]

We deleted a navigational attribute from an infoobject before un-checking it in the relevant multiproviders and cubes. This caused the cubes and multiproviders to be inactive. We were able to manually go in and activate all of them. Every thing got collected in a transport. But the transport generated an error code of 12.

Majority of the relevant cubes are active in QA but two of them are inactive. Checking the log and ST22, we can see that it was failing to activate a transformation. We activated the transformation thru the program RSDG_TRFN_ACTIVATE. We will try a reimport and see if that works.

I wanted to check if there is any thing else that needs to be done. I know we should have unchecked it in the multiproviders and cubes before removing it. But mistakes happen. If we are unable to activate the cube in QA, can we put the attribute back and then go from there? What other options do we have? Thanks.

[Loed · Accepted solution]

Hi Uday,

Did you still encounter any error on this? Can you post it?

Regards,

Loed

[former_member730190 · Accepted solution]

After 2 reimports, we were able to get the transport in Prod without errors. I had to activate a transformation thru the program and then do a reimport. That worked. I think it was getting stuck on that one transformation, and as soon as it failed, it aborted the transport. So once that got fixed, the reimport was fine.

[RamanKorrapati · Accepted solution]

if issue was resolved please close the thread by choosing correct or assumed answer.