Issue with Loading Data Source from SAP S/4HANA ODP to SAP Datasphere via Replication Flow

[Priyanka_27]

Dear Experts,

I am facing an issue while trying to load data from SAP S/4HANA ODP to SAP Datasphere through the Replication Flow. Despite following the steps, no data source appears in the selection screen (as shown in the screenshot).

However, when I attempt to load the same data source using the Remote Table option, the data source (e.g., 2LIS_11_VAHDR) is visible (as shown in the screenshot).

I suspect there might be some configuration or access issue specific to ODP in the replication flow. I would appreciate it if you could share your experiences or insights to resolve this problem.

Thank you for your support!

Best regards,

Priyanka

[EagleEye]

Hi Priyanka,

Check whether the datasource ODP enabled or NOT? you can enable it by going to the tcode SE38 and Enter RODPS_OS_EXPOSE and then just execute. After Executing, Enter the appropriate datasource which is to be ODP enabled in the Release datasource page. Once you enter the datasource and release the datasource, the datasource becomes ODP enabled and it can be now consumed in SAP datasphere. 

Regards

srinivas