cancel
Showing results for 
Search instead for 
Did you mean: 

Issue in Target message monitoring

Former Member
0 Kudos

Hi all,

I am having an issue in message monitoring. I had created a Simple file ---> file scenario.

My doubt is: Though i am able to see the target message as desired in the file system(with all the mapping done), while checking the same in Message & Channel monitoring of SAP PI, its showing only source message payload for both inbound and outbound message. I am not able to see the exact target message.

Below is the path which I had followed to monitor the messages.

Config & Monitor -->  Adapter Engine --> Comm Channel Monitor ---> Search for my receiver adapter --> selecting the message id.  

P.S: I am using SAP PI 7.40

Could anyone help please?

Accepted Solutions (1)

Accepted Solutions (1)

former_member186851
Active Contributor
0 Kudos

Hello Vamsi,

Enable the logging after mapping as per the below link

Former Member
0 Kudos

Hi Raghuraman,

Thanks for the reply.

The suggested link was very resourceful

Answers (0)