Init Without Data Transfer

[Former Member]

I have done init with data transfer for some data selection and it took 1 hour. Now i am doing the same load with init without data transfer, how much time it can take?

Data source is 0fi_gl_4

[Former Member · Accepted solution]

Hi

You will not be able to do init when you have already done Init.

Init without data transfer should take very less time.

Sorabh

[Former Member · Accepted solution]

i deleted the init and re-initalizaing it again.

Its bign almost 1/2 an hour my requesting is running? Is this the problem because of 0FI_GL_4 data source.

[Former Member · Accepted solution]

So you want o do renitialization without data transfer?

You can loose the data if you are doing this.

Try running RSA3 and check if your data source is working fine or not.

Also is your 0FI_GL_4 delta enabled?

There is BADi activation if tht is delta enabled

Cheers

Sorabh

• Assign point if I am help to you**

[Former Member]

Init with out data transfer should not take much time..

Regards

Rohini

[shanthi_bhaskar]

<b>

hi

<i>1.when datasource is not suppoting or

2.when the historical data that extracted through init is not required</i> then we will go for init with out data transfer in this it will create DS to delta.

it will take less time y bec'z it fetches only one record

from one record.this process also known as <u>pseudo delta</u>....