on 2008 Apr 29 10:50 PM
I am processing an inbound idoc file using RSEINB00. It is creating an idoc in status 56. I am not able to figure what is wrong. Please suggest. Here is the error.
EDI: Receiver port in control record is invalid
Message no. EA602
Diagnosis
An error was identified in the control record while adding an inbound IDoc. The recipient ID is invalid:
The receiver port has an invalid value: ZCLR
Procedure
Please inform your system administrator.
Thanks,
Lavanya
Hi lavanya..
I am facing the same issue.. May i know how you resolved it?
Siva
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
I felt it would be useful to someone even it is the older post. I have recently faced issue and got resolved. If you observe the control record there might be the Receiver port and Sender port are maintained same.
Go to Transaction WE19 -> enter your failed Idoc number and execute -> Double click on Control record segment.
The receiver port should be your SAP system id.
Thanks,
Prakash S.
Hi,
Please check in WE21 whether the port is valid or not.
Regards
Abhishek Raj.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Lavanya,
Please Check the below code from include LEDI1F01.
*IF CONTROL-RCVPOR(3) NE 'SAP'
OR CONTROL-RCVPOR+3(3) NE SY-SYSID(3).
MESSAGE E602(EA) WITH CONTROL-RCVPOR
RAISING OTHER_FIELDS_INVALID.*
Conditions
1.IF CONTROL-RCVPOR(3) NE 'SAP'
It means that Reciever port first three chars should be SAP and
2.CONTROL-RCVPOR+3(3) NE SY-SYSID(3)
should be equal to sytem ID .
I hope it definitely resolves ur problem . Please let me know if u have any Query.
Rgds
Sree m
Edited by: Sree Merugu on Apr 30, 2008 4:52 PM
Hi all,
Thanks for the response. I had not checked the 'Unicode Format' in the system settings because if I checked that it is not able to open the file. It gives out an error. So I had unchecked it. I did an access test also and it is successful.
I am processing the inbound idoc file using the program RSEINB00 and I dont see the include LEDI1F01 in that.
Any other ideas?
One more question - is it necessary to create a distrubution model in this case?
Can someone halp me over this?
Thanks,
Edited by: Lavanya Boora on Apr 30, 2008 5:27 PM
Hi Lavanya ,
If u want to use filters , data conversion , version change then go for Distrubution model.
and
I am quite happy u resolved the first issue .
Can u explain the above solution(Navigation or Transaction plz) little bit clearly that how u achieved .
LEDI1F01-check the imported fields and check the reciver information.In u r free time plz put a break point at above include program and check the Unicode format try is it triggring or not .
Rgds
Sree M
It seems that given receiver port is not valid one. Just check that port configuration
Thanks,
Srinivas
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
66 | |
10 | |
10 | |
10 | |
10 | |
8 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.