cancel
Showing results for 
Search instead for 
Did you mean: 

How to post message to multiple receivers

Former Member
0 Kudos
94

For a file 2 file scenario how to send a file to multiple receivers and what are the configurations to be done at reciever side

please any body help

Thanks

Pradeep Chakravarthy

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

hi pradeep,

for sending msgs to multiple recs (from a single msg) u need to us 1:N multi mapping.

refer this:

http://help.sap.com/saphelp_nw04/helpdata/en/0d/28e1c20a9d374cbb71875c5f89093b/frameset.htm

otherwise the config is same.

regards,

latika.

Answers (7)

Answers (7)

vikas_agarwal
Contributor
0 Kudos

Hi,

read my answer in this thread:

Thanks

Former Member
0 Kudos

Thanks to all for your information

aashish_sinha
Active Contributor
0 Kudos

Hi ,

To send messeges to multiple receivers , you need to specify the recivers in the configured receiver of receiver determination in ID. Also you can use the condition to select the different receivers depending upon the successful conditions.

Inside ID :

go to Edit receiver Determination - > Select your Business Service -> enter condition in xpath at configured receivers. and provide you condition in XPATH. You can also use your context variables here to refer to some conditions.

Hope this will help you.

Regards

Aashish Sinha

PS : Reward points if helpful

Former Member
0 Kudos

Hi Pradeep,

Define conditional receiver by Xpath define as in payload.

in mapping too you can define multiple receiver,

Like any if else, or while statements

for more information

http://help.sap.com/saphelp_nw04/helpdata/en/26/5ccd3bb4560f01e10000000a11402f/content.htm

*PS: rewards points if useful**

Regards,

Sumit Gupta

Former Member
0 Kudos

Hi Pradeep,

Please see the useful post below.

Kindly reward points for useful post.

Vishal

santhosh_kumarv
Active Contributor
0 Kudos

Hi Pradeep,

Specify all the receivers in the configured receiver service in the Receiver Determination.

Also create seperate Interface determination and receiver CC for each receiver.

Regards

San

prateek
Active Contributor
0 Kudos

In Integration Directory, under Receiver Determination tab, u can enter the receiver name. There would be a "+" symbol above to add more receivers. Just mention the other receiver there.

For both the receiver, configure the Interface determination, sender and receiver agreement.

Regards,

Prateek