cancel
Showing results for 
Search instead for 
Did you mean: 

Getting Error while activating the source system

Former Member
0 Kudos

Hi Experts,

        I am getting error while activating the source system of BI T90CLNT090. Can any one help how to solve this issue....however iam attaching the screen shot of my error.

The long text of error message is

Diagnosis

  Incorrect IDoc type ZSBB006 in the ALE defintion of the source system.

System Response

     Error when sending data to BI.

Procedure

     Enter IDoc type ZSBA002 .

Accepted Solutions (0)

Answers (7)

Answers (7)

former_member21257
Product and Topic Expert
Product and Topic Expert
0 Kudos

Hi Narsimha,

The error messages 'RSAR373' & 'RSAR374' can be solved by SAP Note 140276.

Also please refer to SAP Note 524554.

The errors usually occur if source system is not connected properly.

In the OLTP(i.e. R/3) system execute function module RSAP_BIW_DISCONNECT (per Note 184322) to disconnect all obsolete BW links.
Afterwards, execute 'restore' in the BW system.
*** Please note that this FM can only be used in the source-system.

Please make sure that note 184754 is explicitly applied too.

As explained in the note 184322, DO NOT enter a value in the RFC target system column. This parameter MUST be empty. If this parameter is filled with the name of your BW system, then the function module
logs on to your BW system and executes the disconnect in this system.
Particularly dangerous if the system is a productive BW system.

Rgds,

Colum

esjewett
Active Contributor
0 Kudos

Since this is a question about BW, it belongs in the BW space and not the Data Warehousing space. I've moved the thread, but please use the BW space for these types of questions in the future.

Regards,

Ethan

(moderator)

former_member188080
Active Contributor
0 Kudos

Hi,

In WE20 you have to carry out Inbound and outbound IDOC setting..

http://scn.sap.com/thread/159033

http://scn.sap.com/thread/1096697

Thanks

Former Member
0 Kudos

Dear Narsimha

Please check the below note.
1478123

Follow the point number 4 and again restore the connection.

Thanks

Tapan

Former Member
0 Kudos

After system copy? Check WE20 to verify idoc type and config.

Former Member
0 Kudos

you can try by checking the rsbasidoc

former_member182470
Active Contributor
0 Kudos

HI,

On your error message, please click on Question mark symbol to see the details. You can get in touch with your BASIS to resolve the issue.

Regards,

Suman