cancel
Showing results for 
Search instead for 
Did you mean: 

Error message when executing a report

Former Member
0 Kudos

In the report I have an advanced calculation of a key figure including several other restricted and calculated key figures. When I run the report in the development environment, which has little test data, I get an error message and can't open the report:

"Messages:

Entry 6X3IFXMIJEI0X7U0IZJMIVBHZ not found in the DKF"

Probably this is because the values for some of the key figures can't be found in the cube and the calculation is therefore stopped? Is there a way to suppress this error and go on with the calculation of my key figure so that I at least can open the report? In the live environment I don’t want the report to dump whenever a value is missing.

Accepted Solutions (1)

Accepted Solutions (1)

former_member188975
Active Contributor
0 Kudos

Did you check out Note 750156...

Former Member
0 Kudos

Thanks guys

/D

Answers (1)

Answers (1)

somnathkumar
Active Participant
0 Kudos

Hi,

You can enclose the formula of the calculated key-figure within the NOERR() function. This way, if there is any error with the calculation of that key-figure, it will be displayed as zero without affecting other key-figures.

Regards,

Somnath.