DTP activation?

[Former Member]

I changed a rule in my dtp.

after activating the dtp, the dtp is just set to the old version. therefor my rule has not been changed.

how ot activate it?

[Former Member · Accepted solution]

Hi!

I also had this problem several times (change of path to local file). This behaves to be a bug in NW2004S and we are all looking for a patch. The work-around is the following:

1. Do your changes in the DTP

2. Save and activate the changes

3. Leave the BW System including log out (This is no joke!!!)

4. Log in new to the BW System

5. Look into the DTP and you will see that your changes have been saved.

Hope I could help you.

Regards,

Percy

[Former Member]

Hi,

Are you writing a characteristic routine ? If so after saving are you clicking on transfer values?

If not please click on transfer values button.

Regards,

Raghu

[former_member205352]

Are you talking of DTP or transformation ???

[Former Member]

oh sorry about my transformation...

[former_member205352]

After activating restart your transaction RSA1 then load.

P.S: That was a very big confusion between DTP and transformation.:-)

[Former Member]

1. I am in change modus -> I see my routine.

2. I press activate.

3. I return /n

4. asking if i wanna leave without saving changes I press yes

5. starting rsa1

6. transformation is active -> but routine is not there

7. go in change mode -> routine is there again.

i just can't get the changed version to be active ...

[former_member205352]

If you have activated transformation properly it should not ask

asking if i wanna leave without saving changes I press yes

By the way answer to this should be NO.

How are you activaing ??

First do a "check" to see if everything is fine in transformation.

Edited by: Praveen G on May 5, 2009 12:02 PM

[Former Member]

it does not matter if i press no or yes

the inactive versiion never goes active.

i activate with the match on the top...

[former_member205352]

Is it authorization issue ??

The BASIS can set transformation to "Not Changeable".Check on that.

[Former Member]

I am the basis, too

you know where to have a look at?

[Former Member]

Check the routine by clicking the 'Check' symbol located on the top.

Once the code is correct,save it and activate it.

come out and activate the transformations...now go back to RSA1and now you should see it.