DSO to DSO Loading

[Former Member]

Hello Friends,

I recently heard a question from my friend regarding DSO to DSO loading.

If we do a Init from DSO "A"(Source) to DSO "B"(Target), and then I run a Full update again from DSO "A" to DSO "B". What happens to the data in the Target DSO? How & Why the data is resulted in that manner?

No selection condition involved & its an standard DSO.

Can anyone help me on this?

Thanks

Regards

Santhosh KUmar N

[Former Member · Accepted solution]

Hi,

If we do a full load instead to full repair after init, when you try to load the next delta it will not get loaded.

-Vikram

[Former Member · Accepted solution]

Thanks Vikram.

Could you let the reason(why it s happening so?) behind this?

[Former Member · Accepted solution]

Hi,

Delta Loads are not possible after FULL loads when we are loding data into ODS/DSO as it sdoesn't support at all.

Chk the below link

http://sapbwneelam.blogspot.com/2007/09/how-to-do-delta-loads-after-full-loads.html

--

rgds,

[Former Member · Accepted solution]

Basically doing a full repair provies you that your delta is not corrupted and at the same time reapair request can be loaded.

But after the init if you do a full , it will not let you do load delta.

Hope this clears you , also this concept is at many places in SDN , please perform a search for full repair and delta.

-Vikram

[Former Member]

thanks...