cancel
Showing results for 
Search instead for 
Did you mean: 

Direct and Flexible loading for Attributes for a Info-object?

Former Member
0 Kudos

Dear all,

Is it possible to have both Direct and Flexible update for Attributes of an Info-object from two different data sources from the same source system(R/3) . The reason being that the first data source can not be extended in R/3.

When this scenario is tried For Flexible loading The data loading is not successful in BW.No errors/dumps found.

Regards,

Amu

Accepted Solutions (0)

Answers (1)

Answers (1)

Former Member
0 Kudos

I've already had used it in different scenarios. Did you check ST22, SM21 and the job log?

Best regards

Dirk

Former Member
0 Kudos

Dear Dirk,

I have checked ST22, SM21 and the job log?

No errors observed.

In the monitor Processing get completed But not getting updated to the info object. Hangs on Yellow.

Regards,

Amu

Former Member
0 Kudos

In this case I start and activate the whole data flow again to hopefully get an error message. If this still has no success I'd open an OSS message. Even if you have made a mistake you should get an error message somewhere.

Some other places you might check:

SM50 to see if the job is still running

DB02 to see DB locks and tablespace problems

Best regards

Dirk