cancel
Showing results for 
Search instead for 
Did you mean: 

DELTA LOAD query

Former Member
0 Kudos

Hi Experts,

I have one query regarding DELTA LOad into Infocube.

One of my process chain failed at DELTA load of Infocube on sept 4.

Next load on 5 th is also failed .

So if i do full load for these two days then i set it to intial load without data. Will next Delta load on tommorow i.e on 6 th sept be fine. Does it work. Please advice me.

thanks in Advance

View Entire Topic
Former Member
0 Kudos

hi,

first check the status of both loads.. if they r in red then proceed with reinit with data transfer once it is completed then change it to delta and save...

before this u need to delete te previous init

Siddhu

Former Member
0 Kudos

Hi

I would not suggest to go for reinit.

Instead I would suggest you to once again change the failed request to red once again manually.

Then delete failed request. And then try repeat delta. And your repeat delta should take care of your 4th and 5th delta.

Incase after checking you still find that all data is not loaded then go for full load with some selection parameter which should fill your requirement. But note that you will have to set repair flag in case you are doing full load in ODS. Once repair flag is set you can then carry on with delta loads.

Regards,

Rohini

Former Member
0 Kudos

Thanks Rohini.

I did the repeat . IT worked fine. I have verifed ODS data count with Infocube count.

Thanks a lot