cancel
Showing results for 
Search instead for 
Did you mean: 

Creation of Hierarchial datasource in 7.0

Former Member
0 Kudos
59

Hello,

I want to create an extractor ( 7.0 ), for loading hierarchy into an infoobject. I came to know that its not possible to create Hierarchial datasource

in 7.0 flow ( possible only in 3.X).

still is it possible to create one through RSA2 transaction?

In RSA2, if i create a new datasource, there is a field DataSource Type--> and the F4 help gives an option of HIER ( Hierarchy nodes )

is it the right way to create one??

Thanks

Karthik

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

Hi ,

using ras1old you can upload the Hierrarchy data (same procedure that you will follow in 3x).

rsa2 is not the procedure.

Regards

Ramakanth.

Former Member
0 Kudos

Hi,

How do we go about it in RSA1OLD transaction ? could you please mention the steps.?

if i do it in RSA1OLD transaction, i am just thinking it will become 3.x flow, becasue i have to deal with info source and transfer rules.

Thanks

Karthik

Former Member
0 Kudos

Hi Karthik,

you need not create the data source in rsa1old, you can create the 3.x datasource for flatfile(Hierrachy load) in you BI 7.0 rsa1 transaction.

follow the same steps as you would in 3.x system.

1) hierarchy defined for the Infoobject

2) create the flat file datasource, with the field structure for Hierarchy load (node ID, infoject Name ....)

3) create the 3.x Infosource

hope this helps...

Regards,

Umesh

Answers (3)

Answers (3)

former_member205352
Active Contributor
0 Kudos

Have you tried transaction BW10 for creating datasource.

May be that may help.

Former Member
0 Kudos

Hi,

Thanks for your reply.

The BW10 transaction does not seem to exist.

And i followed the steps mentioned in the link. In step 3, after entering the source system, i am getting a pop-up where i am asked to select

a datasource.

Here there are only two datasources present for selection

one is attribute datasource , other one is datasource for loading text. ( which were already there).

Here i am supposed to get another datasource name ( Hirearchial datasource ). I know that i have to create one before following the steps mentioned in the link.

( So that i get my hirearchail datasource name for selection in that pop up )

my question was how do i go about creating this datasource. In RSO2 transaction , i can create datasources for loading text, attributes and transactional data.

There is no option for creating Hirearchail datasource.

former_member205352
Active Contributor
0 Kudos

BW10 is transaction and to be used to create datasource in R3 side not BW.

former_member205352
Active Contributor
0 Kudos

Isnt RSA2 for display of datasources ??

Anywayz for your hierarchy check the below link :

http://help.sap.com/saphelp_nw04s/helpdata/en/80/1a6729e07211d2acb80000e829fbfe/frameset.htm

Hope this helps.

Former Member
0 Kudos

Doubt not yet cleared