Conversion of logical system names in queries

[Former Member]

hello,

We have the following problem in our multisource model.

Constant values have been assigned in queries in development : for instance, in line 1, the profit center is restricted to the constant value D3/9000/TTBC600

D3 : development source system

9000 : controlling area

TTBC600 : Profit center code

When we transport the query, we were expecting a conversion of the source system ID in this constant value but it is not the case.

could you tell me if this is a normal behaviour??

If yes, it means that we have to enter constant value in hard code without reference to the source system ID (indirect input, you cannot enter more than the length of the object i.e. TTBC600 in this case) and this can be at the origin of conflict if we have same code in different source system.

Thanks in advance for any answer

OD

[Former Member · Accepted solution]

Did your transports move up ok to your target system?

I am asking because your problem could be your mapping of source system to source system ID is not set up correctly or your "conversion of source system names after transport" is not set up correctly in your target system.

[Former Member · Accepted solution]

yes the transport of query is done with RC=0

According to you the conversion should be done for this constant value?

[Former Member]

still not answered !