Communication Channel Monitoring Empty

[dhagigeorgiou]

Hello everyone,

We have a RFC -> XI -> HTTP scenario. The interface is synchrous.

When executed we get a TCP/IP error saying that the program id is not registered.

BUT the program id is in the rfc sender adapter.

In the Communication Channel Monitoring (RWB > Component Monitoring > Adapter Engine) we can not see any of our adapters. I suspect this is where we are fault.

Any takers?

Thanks,

Dimitris

[prateek]

<i>In the Communication Channel Monitoring (RWB > Component Monitoring > Adapter Engine) we can not see any of our adapters.</i>

Do u mean u r unable to see the communication channels? Inside communication channel monitoring, we see the communication channels. Adapters are seen under the Adapter Monitoring tab.

Regards,

Prateek