cancel
Showing results for 
Search instead for 
Did you mean: 

Cannot load Master data using DTP

Former Member
0 Kudos

When we are loading master data through DTP it showing a message already red request exists so do we "delete" or "repair" ?

If we choose "delete" option we are getting MESSAGE_TYPE_X Dump and in the error analysis it is showing

Short text

     The current application triggered a termination with a short dump.

What happened?

     The current application program detected a situation which really

     should not occur. Therefore, a termination with a short dump was

     triggered on purpose by the key word MESSAGE (type X).

Error analysis

     Short text of error message:

     *** Data request to source system / communication *** >> 049 ***

and if we choose repair also we are getting dump MESSAGE_TYPE_X Dump but in the error analysis it is showing

Short text

     The current application triggered a termination with a short dump.

What happened?

     The current application program detected a situation which really

     should not occur. Therefore, a termination with a short dump was

     triggered on purpose by the key word MESSAGE (type X).

Error analysis

Short text of error message:

*****  Scheduler

Long text of error message:

Technical information about the message:

Message class....... "RSM1"

any help..

Thank you

Accepted Solutions (0)

Answers (3)

Answers (3)

Former Member
0 Kudos

Hi Angaval,

You can also change QM status to green by FM RSBM_GUI_CHANGE_USTATE. Then delete the DTP request and start the fresh load.

Former Member
0 Kudos

Hi

Make the QM status red(forcefully though its red) and then try to delete the request.

If you are not able to delete then use function module RRSM_DELETE_REQUEST(if you are loading to infocube).

Regards,

Shilpa

Former Member
0 Kudos

Hi,

There is an request whose status is red in the target. Try to manually delete the request and try to reload the data into it.

Check for details in st22 for short dump.

Check the Note 410405 - Termination MESSAGE_TYPE_X after implementatn of Note 408612

Check the following links..

http://scn.sap.com/thread/3146211

http://scn.sap.com/thread/2104717

Regards,

Aravind.