cancel
Showing results for 
Search instead for 
Did you mean: 

Can any one brief me about Routing and Pipiline

Former Member
0 Kudos

Hi all..

Can any one brief me about

<b>Routing and pipeline</b>

and plz <b>let me know,where are these terms used in XI</b>

Thanks In advance...

Cheers,

Raghavesh Reddy

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

Hi ,

Check this thread also..

Sekhar

Answers (2)

Answers (2)

Former Member
0 Kudos

Hi Raghavesh,

Routing is one of the steps of the pipeline process.

When a source message reaches the Integration server, it performs 6 steps before the message reaches the destination. The steps are:

1) Receiver Determination: This steps determines the system that participates in the exchange of the message.

2) Interface Detremination: For each receiver determine which interface will should receieve the message.

3) Message Split: If more than one receievers are found, Xi will instantiate new message for each receiver.

4) Message Mapping: Mapping to transform the source message to destination message format.

5) Technical Routing: Bind a specific destination and protocol to the message.

6) Call outbound Adapter: Send the transformed message to the adapter or a proxy.

One can examine these steps in Runtime Workbench using the Transaction: SXMB_MONI.

Regards,

Ashish

Former Member
0 Kudos

Hi Ashish..

Thanks for ur reply...

but..i dint get where is the routing happening..

Can u just brief me out..

Cheers,

raghavesh

Former Member
0 Kudos

Hi ,

<i>where is the routing happening</i>

Routing is happening at Adapter engine...It will take care of the Routing during Technical routing event.

Check this blog for understanding message flows in XI.

/people/siva.maranani/blog/2005/05/25/understanding-message-flow-in-xi

Sekhar

Shabarish_Nair
Active Contributor
0 Kudos

From Help doc:

Technical routing is the Processing step of the Integration Engine that determines physical addresses of logical receivers.

The physical address (end point) of the required receiver is retrieved from the Integration Directory.

So this is where ur receiver is binded to your communication channel

bhavesh_kantilal
Active Contributor
0 Kudos

Hi,

Pipe line services is the series of steps by which your msg from source reaches target. The steps involved are

1. Sender Agreement

2. Receiver Determination

3. Interface Determination

4. Message branch according to receiver

5. Request Message mapping

6. Technical routing

7. Call adapter

Regards,

Bhavesh