cancel
Showing results for 
Search instead for 
Did you mean: 

Auto-ID not working properly

Former Member
0 Kudos

Hello,

I configured my R/3 4.7 and when I use BD10, I get a "successfull send material".

In WE02 there is a green light and status 3 for the idoc.

Now I was looking in my NWE system (no XI in between, because I think it can work without) under autoid => product. But it is empty.

I did nothing under "product". Do I have to search for a category or should the material be displayed when I enter this function?

Which settings do I have to configure in AII / NWE System to make it work?

Accepted Solutions (0)

Answers (1)

Answers (1)

prateek
Active Contributor
0 Kudos

Actually this is not the right forum for this question unless u use XI and the problem occurs during communication with XI. U should use Expert Forums » SAP NetWeaver - Auto ID Infrastructure » SAP Auto ID Infrastructure

I would say that first check in sm58 of R3 and if it is empty then u can ensure that data is sent out of R3 system properly. This will help u

http://help.sap.com/autoid20/helpdata/en/cf/608fc93d7cf14aa5ad7cc470e45593/content.htm

Regards,

Prateek