cancel
Showing results for 
Search instead for 
Did you mean: 

2lis_03_bx MCNB

Former Member
0 Kudos

Hi,

I have run set up for stock intialization in MCNB . It showed around 9808 records selected from extractor. But the same are neither reflecting in MC03BX0SETUP nor in RSA3.

Kindly help.

Accepted Solutions (0)

Answers (4)

Answers (4)

Former Member
0 Kudos

hi,

try in RSA3 without giving the selection conditions. also the MC03BX0SETUP will show somw data if you have looked in the se16/se11 tables but those datas will not give any relevent information other than presence of data.

Ramesh

Former Member
0 Kudos

Hi Everyone,

Set up table and RSA3 options are not working to see data.

Infopkg is giving idoc error : " Incomplete Control parameter for communication with the source system " . Our plug in is PI 2004.1 . Please suggest what can be those control parameters ?

Former Member
0 Kudos

hi,

first chk the source system connectivity with Bw server.

RSA1-> source system -> select the source system -> right click check.

if the connection is not ok , consult basis for the connectivity.

Ramesh

Former Member
0 Kudos

Hi Ramesh,

I have done RFC connectivity test for source system from BW, its working fine.

Can you suggest me what can be those control parameters ?

regds,

Jay

Former Member
0 Kudos

hi,

have you tested any other load from that source system and is working fine?

hope chk the general settings in SBIW BW for the data transfer. like frequency,source systemsetc..

Ramesh

Former Member
0 Kudos

Hi Ramesh,

I have checked at R/3 System side :

Control parameters defined here are :

Srs system = T90CLNT090

max kb = 20000

frequency = 10

max proc = 3

target system = nil

max dp = nil

Also, its not defined in sap bw sbiw .

Please suggest !!

Former Member
0 Kudos

Hi Everyone,

Thanks for the support and help.

The problem sorted after i referred to sap note 631345.

The data is now visible in RSA3.

regds

Jay

Former Member
0 Kudos

For this extractor you should be able to see the data in the setup table of BX. I did it yesterday and i can see it.

Former Member
0 Kudos

There are some extactors that not show the data in RSA3 you must check your extraction from BI side

Regards

Former Member
0 Kudos

Hi Jay,

Ideally we should be able to find them out in RSA3, but may not be in set up table.

Anyhow, try running an generate init load from BW and check.

Naveen.A

Former Member
0 Kudos

Hi,

I have tried running init load twice but of no use.