cancel
Showing results for 
Search instead for 
Did you mean: 

0FI_AP_4 & 0FI_AR_4 not pulling any data on init

Former Member
0 Kudos

First the background: We are on PI 2004_1_46C. The 0FI_GL_4 extractor is already in use with deltas. This is a new project to implement 0FI_AP_4 and 0FI_AR_4 (new InfoProviders). 0FI_AR_3 and 0FI_AP_3 are in use but these dataflows are going to be removed.

Situation: Trying to initialize 0FI_AP_4 and 0FI_AR_4 but no data comes in the initialization. We verified that there is indeed data in the R/3 system. We ran the deltas first for GL in case there were any dependencies and still no data in the inits. Full load works fine.

Thanks in advance for your help.

Susan

Accepted Solutions (1)

Accepted Solutions (1)

Ashwin
Active Contributor
0 Kudos

Hi!

welcome to SDN.

have you tested in source system i mean in RSA3 what is the result. if it is working with Full load. then load the data with fulload and run initialzation without data tansfer.

with regards

ashwin

Former Member
0 Kudos

Ashwin,

Thanks for the suggestion. I will try that, but we are trying to have a solution for when this design goes into production. Won't this method require that the production source system be idle so that no changes are made to the data that was loaded in full?

Ashwin
Active Contributor
0 Kudos

normally yes it requires that there is no change to the data since full load. but you have to trace out the problem by debugging the source system. areyou getting any error or warning mesages. check the system logs and idocs from source system for details.

with regards

ashwin

Answers (0)