cancel
Showing results for 
Search instead for 
Did you mean: 

Storage process and process step not written into HU header after picking

schulte-bahrenberg
Contributor
0 Kudos
2,385

Hey guys,

requesting your help for the follwing problem.

I have a storage process on outbound side with two steps (picking & loading). So after picking the HUs are placed on staging and from there loaded to truck.

I create the WTs and storage process and process step is written in the WTs correctly. Now I start picking and confirm the HUs to the destination bin (which is staging in our simple process). For any reason the storage process and the process step is not written into HU header. After picking I would have expected the picking step there and the step completion flag.

Any idea what is missing in customizing or where I could check for the reason.

Note:

We have two different picking processes - it is not working for any of them:

- pick complete HU from bulk -> here the level of available qty in storage type is the location and user enters HU during picking -> HU is placed on staging and storage process & step not in HU header

- pick from pick bin into pick-HU -> Pick-HU is placed on staging and storage process & step not in HU header

Thanks in advance for any advice!

Hendrik

Accepted Solutions (0)

Answers (2)

Answers (2)

schulte-bahrenberg
Contributor
0 Kudos

Hi Phani,

I setup a loading step now in addition to the existing picking and staging step. Now after having confirmed the pick (either remove existing HU from source bin or pick product into pick-HU) the storage process and step is written into HU header. You know the reason why this is not being done in case I do only having picking and staging step?

Actually we are not doing complex loading with WTs so I wanted to avoid having the loading step in the POSC.

Thanks

Hendrik

0 Kudos

@Hendrik, were you able to get this issue resolved. What was the solution?

Former Member
0 Kudos

Hi Hendrik

Share screen shots of configuration. It will help understand issue. Your storage process should be setup with 3 steps (pick, stage, Load). Your post says it has only two steps. Process oriented storage control config, will not have any step for picking. Set rule based destination determination for staging & loading steps. This should do. Let me know.

Best Regards

Phani sai

,

Hi Hendrik

I think your storage process should have 3 steps (Picking, staging. loading). In process oriented storage control config for determining destination bin...there will not be any step for picking. Set rule based destination determination for staging step. This will determine staging area from "staging are door determination setup". Similarly rule based destination determination for loading step. Screen shots of your config will help, pinpoint issue.

Regards

Phani sai