Query on use of Requirement Profile in gATP

[SAPSupport]

Dear Team,

We are checking the feasibility of using requirement profile in gATP. Through requirement profile we want to overwrite the Check Mode specified in product master with the one specified in requirement profile.

We checked and observed that during manual ATP check(through ME22n) system is considering the Check Mode correctly from requirement profile.

But need to check with you if through /SAPAPO/BOP and /SAPAPO/BOPI as well it give preference to Requirement Profile?

If yes, then is there a way/spot where we can check which check mode is being used per document during run time?

Thanks & Regards

------------------------------------------------------------------------------------------------------------------------------------------------
Learn more about the SAP Support user and program here.

[former_member717928]

Hi Michael,

The purpose for which we are planning to set up requirement profile is to avoid(even by mistake through BOPI) executing ATP check which will trigger product allocation.

Through requirement profile we are planning to set up Check Mode and against that check mode we have set up the check instruction which will not have Product Allocation step.

So as a next step we wanted to make sure that in any of the way system will consider check mode only from the requirement profile.

- Through ECC when we carry out the ATP by default it consider check mode from requirement profile.

- For BOP as you explained we can make use of use exit "EXIT_/SAPAPO/SAPLBOP_040" to overwrite check mode with the one from requirement profile.

- Similarly we wanted to check an option for BOPI as well where in we can replace default check mode(picked up either from /SAPAPO/ATPPARAM table or product master) with the one from requirement profile.

Thanks & Regards

Shashank