Showing results for 
Search instead for 
Did you mean: 

PO output for PORDCR1.PORDCR102

Former Member
0 Kudos

Hi Gurus

We are using PORDCR1 idoc to send the PO output to SNC. I have set up distribution model and NACE config as mentioned in thread

However instead of maintaining PO output condition record for output type with spl function as medium, the output is not getting generated in PO after saving the PO. I need to enter output conditions in PO manually and then the idoc getting created.

Please help me if I am missing any other setting?

Will appreciate your early help



Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos


There can be 2 different reasons for the resolution of the problem. Firstly i can unsure that this is related to SNC output configuration settings:

1- You can check the below customizing under t-code EL --> Your output condition:

You need to ensure that below check is not exists:. "Manuel only line should not be there.

2- Kindly make the we20 settings like below:

Do let me kow the results...


Selim Batur

Answers (0)