Showing results for 
Search instead for 
Did you mean: 

Project Upload (RPM_DX) - inititative status upload - concern

Former Member
0 Kudos


We are on PPM5.0.

We are using the standard template for Project upload.

Under transaction RPM_DX, while using the initiatives upload, we have some concerns.

We are able to upload the initiative. However, we have not been able to figure out:

1. Under the "Initiative" tab sheet (of the upload template), what value to put in the SYSTEM_STATUS column to see the initiave as "Released"

2. Under the "Decision Point" tab sheet, what values to put for the Decision Point status to see the Decisio Point status as "Released", "Completed" etc.

We have a scenario where we have 5 decision points (for the Initiative we are using). After upload, we intend the Initiative to have been done with 3 Decision Points, and be at the 4th one.

Please advise on the permisible status values to be entered in the upload template for:

1. Initiative

2. Decision Points


Accepted Solutions (0)

Answers (1)

Answers (1)

0 Kudos

Hello Deepak,

Initiative status management is same as status management in Project, you can find the system status ID for released status from the transaction where you maintain the Project's system statuses.

For Decision Points you can refer the Initiative Type configuration where you have maintained the decision points and its statuses for the initiative Type. you would need to put Status IDs and set the active Decision point flag accordingly.

Hope this help.

Thanks and Regards,