WM Source bin not determined automatically during pick

[yogesh_agarwal2]

Hi All

For GI to delivery, when I do pick using LT03, system does not populates the source details automatically:

I think, it is because the SUT is not populated automatically

But, the palletization data is maintained for the part:

Also, Storage type check is active and indicator maintained correctly

No storage section check is active

for storage type 210, all SUTs are allowed

Also, when I manually enter the SUT as AA in the transfer order, system picks the bin from 210,

but does not populates the QUANT & SU number:

In LS26, there is a enough stock available, all with Quants and SU numbers in GATE1 bin

Please suggest!

Best Regards

Yogesh Agarwal.

[former_member253035]

Please check whether SU Management is active for storage type

[yogesh_agarwal2]

Hi Vineel

Yes the SU management is active and all quants in that storage have SU numbers, too

Best Regards

Yogesh.

[Former Member]

Have you just recently activated ST / SUT check (meaning previously it was not activated)?

This sounds like a similar challenge:

[MANIS]

Check whether storage type search strategy is defined in the configuration for the indicator 210 under the node.

LE----WM-----Strategies ----- Activate storage type search strate

When you are entering the storage type manually what is the error message you are getting at the bottom

Message was edited by: Manish Kumar

[yogesh_agarwal2]

Hi Manish

Thanks for the reply

The strategy is maintained in T334T for storage type indicator 210:

When i enter the SUT manually in TO, I get no Error but the below message:

Best Regards

Yogesh.

[MANIS]

that is for information not an error......press enter once and check what is the message system shows

Also check the configuration for storage unit type and Storage bin type under

LE ----WM-----Strategies ----Stroage bin type search

here for your storage type 210 storage unit type should be defined and subsequently for the same SUT  storage bin type needs to be defined

Message was edited by: Manish Kumar

[JL23]

Why did you hide the warehouse number in your T334T screenshot.

In your other screenshots the warehouse number is visible. This makes it impossible to evaluate whether your setup is matching with the data in the transfer order.

[yogesh_agarwal2]

Sorry Jurgen, PFB:

[yogesh_agarwal2]

There was no error, the system proceeds to create the TO

For SBT search, system has been configured below:

Warehouse      ST             SUT

GLA                210            ***

[MANIS]

if i refer the earlier thread(screenshot) then your setting should be

GLA   210   AA (here AA is the Storage unit type which is allowed into storage type 210)

and for Storage Unit type to Storage bin type it should be

GLA  AA    AA ( in this case Storage unit type AA is allowed to store into Bin type AA)

Also check the "Reference storage type "  in WM Movement type as per your T334T screenshot there should not be any entry in "reference storage type" field