cancel
Showing results for 
Search instead for 
Did you mean: 

Valuation mode - multiple limits

demo
Explorer
0 Kudos
279

Hi experts,

I have the following scenario:

Sampling procedure used:

Sampling type = Fixed sample

Valuation mode = Attributive inspection nonconf. units

Determination rule = Fixed sample

Inspection points = Free inspection pts

Sample size = 5

Acceptance number = 1

Inspection frequency = 1

In Inspection Plan, the quantitative Inspection Characteristic have Upper limit = 500.

Results confirmation = Single result and Required char.

So, that still permits 1 nonconforming units or defects in a sample acceptance of the inspection lot.

However, this out-of-specification result could not be greater than 2000, otherwise, the inspection lot should be rejected.

Is it possible to configure this?

Thanks

Regards

ED

View Entire Topic
former_member42743
Active Contributor
0 Kudos

I don't think that is possible.

You have to write your own function mode to do the valuation and config that in as a new valuation mode.

Craig

demo
Explorer
0 Kudos

Thanks Craig for the attention and comment.