cancel
Showing results for 
Search instead for 
Did you mean: 

tolerance key

Former Member
0 Kudos

when i am selecting tolerance key as "a10" and target value "3", i am getting the warning message as below

Check the target value. Tolerance key is used

Message no. QS172

Diagnosis

You have selected a tolerance key for which the target value is NOT

copied over.

Procedure

Enter a target value that meets your requirements.

And if i enter then i am getting next error message as below

Target value is greater than an upper limit

Message no. QS131

Procedure

Select a target value that is between the current lower and upper limits

or delete the setting of the control key "Check target value".

Message was edited by:

sandip raut

Accepted Solutions (0)

Answers (1)

Answers (1)

Former Member
0 Kudos

Hi Sandip,

This has been answred in similar question raised by you on an earlier date. PLease check it.