Showing results for 
Search instead for 
Did you mean: 

System error: Error when copying parameter function group CR01

Former Member
0 Kudos

Dear friends

I am getting the above error while doing the Backflushing in REM.

It occurs when backflushed quantity is issued ,and while confirming the

ACTUAL ACTIVITES above error occurs..........

We have upgrade the system from SAP 4.7 to ECC6.0.

It is giving some error in CRM system but we don't have CRM system.......

Message displayed is as below..................

System error: Error when copying parameter function group CR01

Message no. CR085


Internal error.


Repeat the transaction.

If the error occurs and you have a CRM System connected to your ERP

System, the document may have been archived in the CRM System.

If the error occurs again, inform your system administrator. If the

error cannot be corrected, call the SAP Hotline directly. Describe which

steps preceeded the error.

Thanks& Regards


Message was edited by:

Sandeep Bhowmick

Accepted Solutions (0)

Answers (4)

Answers (4)

Former Member
0 Kudos

answered . i close this issue

Former Member
0 Kudos


I get exactly the same message under exactly the same scenario.

Did you find the right solution?



Former Member
0 Kudos

Hi Sandeep

Standard R/3 does not allow backflush without any operation. You need to have an operation to do a backflush.Error message CR 085 is issued because there is no operation in the routing of the material backflushed. System should issue an error when no operations are found in routing. Although, error message CR 085 is not correct, more appropriate message RM 824 for this a program correction is requried check note (691161).



Reward if useful

Former Member
0 Kudos

I think there is something wrong with the workcenters u have set

1. Please check the workcenter for the formulas.

2. Check thr routings for standard vales whether it is defined.