cancel
Showing results for 
Search instead for 
Did you mean: 

Routing unavailable in order through MD04 but available when ordering through CO01.

Former Member
0 Kudos

Dear all,

While creating production order from planned order with MD04, the routing is not available whereas the routing could be seen in orders released through CO01. Can you suggest what could be the possible reasons for this.

Additional data:

With MD04, the order quantity is coming as 9 square inches. But in actual the production unit is set as UNIT in the work scheduling tab of material master. The base unit is Square inches.

Could the problem be related to lot size in routing of the part or the maximum and minimum lot of the part set in material master in MRP 1.

Accepted Solutions (0)

Answers (4)

Answers (4)

Former Member
0 Kudos

Hi,

Could you please check what Saurabhs originally suggested:

Have a look on the following points

1. Valid from date of the Routing

2. Material Requirement date in MD04.

Make sure point 2 is not beyong point 1 please

This might be it,

Alex

former_member201849
Contributor
0 Kudos

Hi UT K

Please check the Order Type in OPPQ --> Conversion of Planned Order to Production Order Order Type and Manually created Order Type same or not.

Regards

Suresh.M

Former Member
0 Kudos

Hi

Please check your order type in MD04 and also in manual creation by co01.

Former Member
0 Kudos

Its same in both cases.

former_member194456
Contributor
0 Kudos

Hello

Could you please have a look on the following points

1. Valid from date of the Routing

2. Material Requirement date in MD04.

Please note if the requirement date in MD04 is earlier than the routing calid from date than the system will not pick the routing data.

Might be the possible reason

Please check

Regards

SS

Message was edited by: Saurabh Srivastav

Caetano
Advisor
Advisor
0 Kudos

Hello

Are you using the same order type in both cases?

BR

Caetano

Former Member
0 Kudos

Hi,

I am checking for the valid from date in routing and material requirement in MD04.

Will update by tomorrow.

Thanks for your reply

Ut

Former Member
0 Kudos

Hi,

The order type was same in both the cases.

The problem may be because of date conflict issues.

Will update by tomorrow after checking.

Thanks

Ut