cancel
Showing results for 
Search instead for 
Did you mean: 

Role BUP010 missing when synchronizing Employee to BP in new model

simonhodge
Discoverer
0 Kudos

We have activated the new BP model for employees in S/4 2021. When we synchronize the employee to the BP using /SHCM/RH_SYNC_BUPA_EMPL_SINGLE we get a BP Employee with role BUP003 created but no BP with BUP010.

SLG1 gives error /schm/employee_BL019 error in updating user with workplace address and as the message is marked as self explanatory there is not much to go on.

I'm about 20 OSS notes deep and have checked the T77S0 along with the suggestions from the notes. Any help appreciated.

View Entire Topic
former_member857234
Discoverer
0 Kudos

Hi Simon,

Did you get the solution ?

We have same issue in productive system and I'm looking for a solution.

Thanks,

Jagruti

simonhodge
Discoverer

Hi Jagruti, It is a bit of a multi layered answer.

First we had to have address type 1. in the Employee master. Then we had an issue where we could not create the BPO without linking the Employee master to and user ID in IT0105. That was corrected by OSS note OSS 3138166.

After that we were golden.

sswaroop
Explorer
0 Kudos

Hi Jagruti,

Did you get any solution for this, we are having the same issue.

Regards,

Sidharth