cancel
Showing results for 
Search instead for 
Did you mean: 

regarding calibration order through QM Module ?

Former Member
0 Kudos

Dear guru's

i have question regarding calibration order **"in our system firstly make order then do all formalities and release and save .**

***when we go to in change t-code then automatically LOT INSPECTION ASSIGNED but in system that is not assigned automatically so plz tell me who will help me or it is a authority problem

regards

atul sharma

9909973893

Accepted Solutions (1)

Accepted Solutions (1)

anup_patil3
Active Contributor
0 Kudos

Hi Atul,

I really did not understood your quey/issue but SAP Calibration process is as below:

You first create Maintenance Plan as Master data.

Then you schedule it using IP10.

After Scheduling, system generates a Maintenance Order automatically.

Then you release Maintenace Order. After release only, an inspection lot is generated (Based on Configuration done).

Then process the Insp Lot and subsequently, process the Maintenace Order.

Now, please confirm what's your query here?

Regards,

Anup

Former Member
0 Kudos

Dear sir,

You are right sir but my question is this after release the order when we re-enter in order there should be lot inspection is assigned automatically but it's not assigning (actually when LOT Inspection is assigned there is a option when we select it that goes to QA13 t-code in display mode but actully this is not possible plz sir

regards

atul sharma

anup_patil3
Active Contributor
0 Kudos

Hello Atul,

You can display Inspection Lot from Maintenance Order (IW32/33) by clicking on Environment --> Display Insp Lot. System will take you to Inspection Lot in display mode.

But if you're saying system is NOT displaying any insp lot that means an inspection lot is NOT created for that order.

Check SPRO if you've assigned Inspection Type-14 to correct Plant & Maintenance Order Type.

Path: SPRO --> QM --> Quality Inspection --> Insp Lot Creation --> Define Insp for PM.

Revert if any further issue.

Regards,

Anup

Former Member
0 Kudos

DEAR SIR,

thank you very much for your answer

regards

Former Member
0 Kudos

dear sir,

In SPRO that is all ok. but i am going IW32 that shows No insp. lot was generated Release order anyway?

so plz do needfully

regards

Atul Sharma

9909973893

Answers (0)